How it all connects

  1. powers everything through a USB cable.
  2. is the tiny computer that runs the show. It sits in the , which gives it easy plug-in ports.
  3. is the single cable between the base and our sensor board (the ASB). It carries both power and data.
  4. boosts the power and sends it down the flat to the .
  5. sits on the AFE. When hydrogen sulfide reaches it, it makes a tiny electrical signal, and the AFE turns that into a voltage.
  6. Back on the , two converter chips turn that voltage into numbers. The Pico W reads those numbers over the Grove cable and can save them or send them over Wi-Fi.
See more details
Power: USB into the Pico W, its 3.3 V out over Grove, stepped up on the ASB to 5 V for the ADCs and the AFEAnalog signal: WE/AE voltages and PT1000 from the AFEI²C: SDA/SCL between the ADS1115s and the Pico WThe part working at this stagePico W in a Maker Pi Pico base; Grove 5 (GP8 SDA, GP9 SCL, 3.3 V) runs to J2 on the SmartCitizen 8-ch board, whose two ADS1115s answer at 0x48 and 0x49. A 2 mm 2×5 ribbon joins J5 to the Alphasense 2-way AFE, with the H₂S sensor in SN1. The AFE is built for 4-pin A4 sensors: use an H2S-A4, not the 3-pin H2S-A1, and seat it in the socket the AFE was configured for.